Met onze cookies willen we u de best mogelijke winkelervaring bieden met alles wat daarbij hoort. Hieronder vallen bijvoorbeeld passende aanbiedingen, gepersonaliseerde advertenties en het onthouden van voorkeuren. Als u dit goed vindt, ga dan eenvoudig akkoord met het gebruik van cookies voor voorkeuren, statistieken en marketing door op “Oké!” te klikken. (show all). U kunt uw toestemming op elk moment nog intrekken via de cookie-instellingen (hier).
Note: Om te voorkomen dat evaluaties gebaseerd zijn op roddel, geruchten of heimelijke advertentie staan wij op onze website alleen evaluaties toe van daadwerkelijke gebruikers die het geevalueerde product bij ons gekocht hebben.
Na inloggen vindt u alle producten die u kunt evalueren ook onder “Product evalueren” in uw klantencentrum.
Ik combineer deze met de shure A56D klem voor optimale onafhankelijkheid waardoor je zo min mogelijk zgn spill veroorzaakt van andere trommels bekkens etc. Super voor mij werkt het👍
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
L
Not the best
LOUKL 17.06.2020
It is not the best I could imagine. Sliding the mic in and out is it not so obvious. It tends to stick to the inner rubber. Test the shock attenuation and I could not find any real benefit.
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
B
Isolates the mic from vibration very well
BernieW 15.12.2022
These mounts really do isolate the mics from vibration effectively, as well as a suspension mount or maybe better, but the problem is that the mic may sag, so you need to find a way to balance it in the mount. This is the one the President uses for speaking into a pair of SM57's with the A57 AWS so if it's good enough for that job it's good enough for us.
It fits an M88TG nicely but the barrel of an M160 is too small (or you can wrap some tape around it). It's designed to fit SM and Beta 57's and 58's and similar. If you fit it at the balance point and clamp the cable to support the back of the mic then it will stay in place but it has a tendency to sag.
But it really does isolate the mic from vibrations very well. If you thump the table or stand with this mic on it using this mount then little of the noise will be heard in the mic.