Met onze cookies willen we u de best mogelijke winkelervaring bieden met alles wat daarbij hoort. Hieronder vallen bijvoorbeeld passende aanbiedingen, gepersonaliseerde advertenties en het onthouden van voorkeuren. Als u dit goed vindt, ga dan eenvoudig akkoord met het gebruik van cookies voor voorkeuren, statistieken en marketing door op “Oké!” te klikken. (show all). U kunt uw toestemming op elk moment nog intrekken via de cookie-instellingen (hier).
Note: Om te voorkomen dat evaluaties gebaseerd zijn op roddel, geruchten of heimelijke advertentie staan wij op onze website alleen evaluaties toe van daadwerkelijke gebruikers die het geevalueerde product bij ons gekocht hebben.
Na inloggen vindt u alle producten die u kunt evalueren ook onder “Product evalueren” in uw klantencentrum.
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
D
Ingenious design
DrCheese 14.01.2021
An ingenious design for a right-angled XLR connector. Easy to assemble and disassemble. Once assembled it won't fall apart easily.
Easy to work with and solder.
Clever design allows you to set the rotation angle of the socket pins with respect to the rest of the connector (before soldering).
Not sure how to remove the socket pins part after it has been inserted into the housing.
Includes a little shroud to prevent the cables from short-circuiting against the metal shell of the connector. This is the part that needs special care and more care than when working with straight XLR connectors.
Usual Neutrik quality. Avoid the temptation to buy cheap XLR connectors which can be unreliable.
Helaas is er een fout opgetreden, probeert u het a.u.b. later nogmaals.
A
Good design with some issues
Anoniem 16.05.2014
I bought several of these right angled connectors for a patch panel that is mounted on the front of a wheeled flightcase, the straight ones would stick out too far and I wanted to leave them connected when the front cover was on. They work well, a bit fiddly to solder due to the design but not too bad. One frustration is that once you have put the pin section into the metal housing, you can't get it out again - so make sure you solder them up before you do this! Also due to the design you can only set the plug up to some predefined angles - every 30 degress or so. No too much of a bit deal but worth bearing in mind if you have a specific need or limited space.